Ecotech Serinus 51 - Figure 11 Device Installer Pop up Window; Figure 12 Device Installer Xport-03

Serinus 51 User manual
1.0
2.
The Serinus analyzer must be configured to allow network use, this is done
through directly connecting it with a PC.
connect the cable from the Ethernet port on the Ser
the PC.
Note:
This step requires a free Ethernet port on the PC. If
port is
being used to connect to the
and
disconnect the cable.
3.
Wait until the connection between the Ser
“Limited or no Connectivity”
4. Open
Device Installer
tutorial (Figure 12
), click No.
Figure
5.
When initial search has completed, access the XPort
hand pane (Figure 13
) by double
6. If the XPort-
03 details do not immediately appear follow the steps below
a)
On the Serinus
Communications
b)
Change the “Operation “ field from
c)
Restart the Serinus instrument
d)
Return to the Network adaptor menu and record the IP address displayed
e)
On your PC change the IP address so that it in an accessible range to that of
the instrument (e.g. Serinus IP address = 169.254.177.48, PC IP address =
1
92.168.253.1). To change IP address on PC
Properties 
Internet Protocol
f) Now the XPort
-
1.0
The Serinus analyzer must be configured to allow network use, this is done
through directly connecting it with a PC.
Using a
crossover Ethernet cable,
connect the cable from the Ethernet port on the Ser
i
nus to a free Ethernet port on
This step requires a free Ethernet port on the PC. If
Ethernet
being used to connect to the
network, stop
all network activ
disconnect the cable.
Wait until the connection between the Ser
i
nus and the PC gives the status
“Limited or no Connectivity”
as seen on the PC. This should
take a
Device Installer
. If a message box comes up asking you to vie
), click No.
Figure
12 Device Installer pop up window
When initial search has completed, access the XPort
-
03 device listed on the right
) by double
-
clicking on it. This will bring up its details.
Figure 13 Device Installer XPort-03
03 details do not immediately appear follow the steps below
On the Serinus
analyzer
enter the Network Adaptor Menu (Main
Communications
 Network Adaptor)
Change the “Operation “ field from
Normal to
Read IP Config
Restart the Serinus instrument
Return to the Network adaptor menu and record the IP address displayed
On your PC change the IP address so that it in an accessible range to that of
the instrument (e.g. Serinus IP address = 169.254.177.48, PC IP address =
92.168.253.1). To change IP address on PC

Local Area connections
Internet Protocol
 Properties
-
03 will be displayed within the Lantronix Device Installer
Calibration
43
The Serinus analyzer must be configured to allow network use, this is done
crossover Ethernet cable,
nus to a free Ethernet port on
Ethernet
all network activ
ities
nus and the PC gives the status
take a
few minutes.
. If a message box comes up asking you to vie
w a TCP/IP
03 device listed on the right
-
clicking on it. This will bring up its details.
03 details do not immediately appear follow the steps below
enter the Network Adaptor Menu (Main

Read IP Config
Return to the Network adaptor menu and record the IP address displayed
On your PC change the IP address so that it in an accessible range to that of
the instrument (e.g. Serinus IP address = 169.254.177.48, PC IP address =
Local Area connections

03 will be displayed within the Lantronix Device Installer