Serinus 51 User manual 1.0
Calibration
51
5.5.3 Remote screen
The remote screen tab allows the user to connect to the Serinus instrument and
control it remotely. The screen has all the same buttons as the Serinus gas
analyzer and is used as virtual interface with the instrument. The screen is a
screenshot and not an automatically updated feed; the refresh button will need
to be used when tracking changes in parameters.
• By clicking the green “Connect” button in the top left hand corner, the
remote terminal session will begin.
• The session can be terminated at anytime by pressing the red
“Disconnect” button
• The screen can be updated by clicking the “refresh screen” button. This
must be used
Figure 19 Serinus Downloader – Remote Screen tab
To Next Page
Loading...
