Ecotech Serinus 51 - 8 Optional Extras; 8.1 Dual sample filter; 8.2 Rack mount kit

Serinus 51 User manual
1.0
8
Optional Extras
8.1
Dual sample filter
The dual filter is designed with two sample filters plumbed in parallel with a split line.
This formation allows sample flow not to be affected, yet reduces the loading
filter, and therefore the frequency with which they will need to be changed.
The dual filter option is shown in the pneumatic diagram (red dashed line) and
requires no operational changes to the instrument.
Figure
8.2
Rack mount kit
The rack mount kit is necessary for installing the
Serinus 51
is 4RU in height to install in the rack follow these steps.
Installing the instrument
1.
Remove the rubber feet from the analyzer (if attached)
2.
Install the two H shaped instrument brackets onto the left and right side of the
rack securely with M6 bolts (two at the back and two at the front) shown
circled in Figure
30
Figure
1.0
Optional Extras
Optional Extras
Dual sample filter
The dual filter is designed with two sample filters plumbed in parallel with a split line.
This formation allows sample flow not to be affected, yet reduces the loading
filter, and therefore the frequency with which they will need to be changed.
The dual filter option is shown in the pneumatic diagram (red dashed line) and
requires no operational changes to the instrument.
Figure
29 Dual filter option installed
Rack mount kit
The rack mount kit is necessary for installing the
Serinus 51
into a 19” rack. The
is 4RU in height to install in the rack follow these steps.
Installing the instrument
Remove the rubber feet from the analyzer (if attached)
Install the two H shaped instrument brackets onto the left and right side of the
rack securely with M6 bolts (two at the back and two at the front) shown
30
.
Figure
30 Installation of rack mount brackets
Optional Extras
69
The dual filter is designed with two sample filters plumbed in parallel with a split line.
This formation allows sample flow not to be affected, yet reduces the loading
on each
filter, and therefore the frequency with which they will need to be changed.
The dual filter option is shown in the pneumatic diagram (red dashed line) and
into a 19” rack. The
Install the two H shaped instrument brackets onto the left and right side of the
rack securely with M6 bolts (two at the back and two at the front) shown