Operation Serinus 51 User manual 1.0
26
• Cycle: performs a zero, then a span then returns to measure
mode. The length of time spent measuring calibration gases is set
in cycle time (below)
• Span: this mode will take air through the calibration port so that a
span calibration can be performed
• Zero: this mode will take air through the calibration port so that a
zero calibration can be performed
==============================================
TIMED MODE
==============================================
-- Date
Enter the date for the first calibration (will display next
calibration time after the first calibration is complete)
-- Time
Enter the time (during the day above) that calibrations
will be performed
-- Repeat
Sets the amount of time between each calibration (from
the above time and date)
Note: The units of the repeat interval can be changed
by pressing the # key (minutes, hours, days)
Span Cal Level
Enter the concentration of span gas used during the timed span
calibrations.
Cycle time
Set the time period that the zero and span calibrations will last for during
Timed Calibration (1 to 59 minutes).
3.5.6 Service
The Service Menu is information used to diagnose problems or suspected
problems. The settings return to the previously set conditions when the
operator leaves this menu.
Diagnostics
See section 3.5.6.1
Calculation factors
See section 3.5.6.2
Save Configuration
Saves instrument EEPROM settings to USB key including (calibration
and communication settings, units, instrument gain etc). If you have
problems with your instrument use this function to save setting to the
removable USB stick and send them to your supplier with your service
enquiry.
To Next Page
Loading...
