Re-register Indoor: Forces the console to forget which indoor sensor it is
receiving and then start “looking” for available sensors and “registering”
the first one found.
Re-register Outdoor: Forces the console to forget which outdoor sensor
it is receiving and then start “looking” for available sensors and
“registering” the first one found. Both options should rarely be needed,
unless you have had to replace indoor or outdoor sensor(s) or in case of
troubleshooting
About: Displays various technical information that may be useful to
troubleshooting or for communication of issues with customer service.
Press MENU to return to the “Factory” mode page.
English: Displays the console’s language. Currently cannot be changed,
but future versions may allow choice of other languages.
Reconnect Wi-Fi: Disconnects the console from the Wi-Fi network and
then lets it reconnect using the already configured network name and
password. This should rarely be necessary but might be useful after you
have moved the console or Wi-Fi access point and want to check the
console is able to re-connect.
Wi-Fi Reset: Reset Wi-Fi to factory setting. This causes the already
configured network name and password to be erased. The console will
enter the Wi-Fi search mode and you will have to use your mobile
application to (re)configure a Wi-Fi connection as described in section
TBD.
5.9 Display Mode for optional sensor(s)
In normal mode, hold the TEMP/- button for 5 seconds will enter the
optional sensor(s) display mode. Press the MENU button can skip to full
display another type of optional sensor(s):
To Next Page
Loading...
