ATTENTION!
• The ECUMASTER PMU is designed for motorsport applications
only and cannot be used on public roads!
• The installation of this device should be performed only by
trained specialists. Installation by untrained individuals may
cause damage to both the device and the vehicle!
• Incorrect configuration of the ECUMASTER PMU can cause
serious damage to vehicle components!
• Never modify the device’s settings while the vehicle is moving as
it may cause an accident!
• ECUMASTER assumes no responsibility for damage caused by
incorrect installation and/or configuration of the device!
• To ensure proper use of ECUMASTER PMU and to prevent risk of
damage to your vehicle, you must read these instructions and
understand them thoroughly before attempting to install this unit.
• Never short-circuit the wires of the vehicle's wiring loom or the
outputs of the ECUMASTER PMU!
• All modifications to the vehicle's wiring loom must be performed
with the negative terminal of the battery disconnected.
• It is critical that all connections in the wiring loom are properly
insulated!
• The device must be disconnected before performing any welding
on the vehicle!
Page 2
To Next Page
Loading...