Why is there no audible alarm on my EDAN Medical Equipment?
If no audible alarm is activated on your EDAN Medical Equipment, first ensure that the audible alarm is not temporarily disabled and switch it on if necessary. If the alarm is enabled but still not working, the loudspeaker or the wire may be defective, requiring replacement.
Why is there no CO waveform on my EDAN Medical Equipment?
If there is no CO waveform on your EDAN Medical Equipment, there may be a bad connection of the CO module. Power off the device and reconnect the CO module. If the problem persists, the CO module may be defective and require replacement.
What to do if EDAN Medical Equipment LCD is black, power is on, and the fan runs?
If your EDAN Medical Equipment's LCD has no display but the power indicator is lit and the fan runs, check if the keys sound properly. If they do, the LCD might be defective. However, if the keys don’t sound, the main control board might be the problem, and you should replace it.
Why is the IBP measurement value unavailable on my EDAN Medical Equipment?
If the IBP waveform is available but the IBP measurement value is unavailable on your EDAN Medical Equipment, the IBP module may not have been zeroed or zero drift may have occurred. Zero the IBP module.
Why does the CO waveform show smooth and numeric value display - - - on EDAN Medical Equipment?
If the CO waveform is smooth and the numeric value displays - - - on your EDAN Medical Equipment, the CO module is likely in standby mode. Change the working mode of the CO module to Measurement.
Why does paper advance lopsidedly on EDAN Medical Equipment?
If the paper advances lopsidedly in your EDAN Medical Equipment, the assembly or location of the recorder may be incorrect. Calibrate the assembly of the recorder.
How to fix EDAN Medical Equipment when LCD has no display, power indicator is off, and the fan doesn’t run?
If your EDAN Medical Equipment's LCD screen is blank, the power indicator is off, and the fan isn't running, start by replacing the fuses. If that doesn't solve it, the power board might be defective and need replacement. Also, check for any short circuits in other parts and fix them.
What to do if EDAN iM80 Monitor displays 'IN DEMO, FAIL'?
If the EDAN Monitor is displaying 'IN DEMO, FAIL,' make sure that the monitor is not in DEMO mode. Contact a service technician if necessary.
What to do if EDAN Monitor displays 'Art SENSOR OFF, FAIL'?
If the EDAN Monitor displays 'Art SENSOR OFF, FAIL', ensure the transducer is not off, and then proceed with zeroing.
What to do if EDAN iM80 displays 'Art ZERO FAIL'?
If the EDAN Monitor displays 'Art ZERO FAIL', make sure that the transducer is not attached to the patient.
General| Display Type | TFT LCD |
|---|---|
| Respiration | Yes |
| SpO2 | Yes |
| NIBP | Yes |
| Temperature | Yes |
| Pulse Rate | Yes |
| EtCO2 | Optional |
| Battery | Rechargeable lithium-ion battery |
| ECG | 3/5 lead ECG |
| Optional Parameters | Cardiac Output |
| Networking | Wi-Fi, Ethernet |
| Weight | 2.5 kg |
To Next Page
