Chapter 5
| SNMP Commands
Notification Log Commands
– 178 –
Default Setting
None
Command Mode
Global Configuration
Command Usage
â—†
Notification logging is enabled by default, but will not start recording
information until a logging profile specified by the snmp-server notify-filter
command is enabled by the
nlm
command.
â—†
Disabling logging with this command does not delete the entries stored in the
notification log.
Example
This example enables the notification log A1.
Console(config)#nlm A1
Console(config)#
snmp-server
notify-filter
This command creates an SNMP notification log. Use the
no
form to remove this
log.
Syntax
[
no
]
snmp-server notify-filter
profile-name
remote
ip-address
profile-name - Notification log profile name. (Range: 1-32 characters)
ip-address - IPv4 or IPv6 address of a remote device. The specified target
host must already have been configured using the snmp-server host
command.
Note:
The notification log is stored locally. It is not sent to a remote device. This
remote host parameter is only required to complete mandatory fields in the SNMP
Notification MIB.
Default Setting
None
Command Mode
Global Configuration
Command Usage
â—†
Systems that support SNMP often need a mechanism for recording Notification
information as a hedge against lost notifications, whether there are Traps or
Informs that may exceed retransmission limits. The Notification Log MIB (NLM,
To Next Page
Loading...
Need help?
General