Chapter 8
| Authentication Commands
Web Server
– 226 –
Default Setting
None
Command Mode
Privileged Exec
Example
Console#show authorization
Authorization Type : EXEC
Method List : default
Group List : tacacs+
Interface : vty
Authorization Type : Commands 0
Method List : default
Group List : tacacs+
Interface :
.
.
.
Authorization Type : Commands 15
Method List : default
Group List : tacacs+
Interface :
Console#
Web Server
This section describes commands used to configure web browser management
access to the switch.
Note:
Users are automatically logged off of the HTTP server or HTTPS server if no
input is detected for 300 seconds.
Table 42: Web Server Commands
Command Function Mode
ip http authentication Sets the method list for EXEC authorization of an EXEC
session
GC
ip http port Specifies the port to be used by the web browser interface GC
ip http server Allows the switch to be monitored or configured from a
browser
GC
ip http secure-port Specifies the TCP port number for HTTPS GC
ip http secure-server Enables HTTPS (HTTP/SSL) for encrypted communications GC
show authorization Displays all authorization information PE
show system Displays system information NE, PE
To Next Page
Loading...
Need help?
General