Chapter 11
| Interface Commands
Interface Configuration
– 364 –
Start Time Discards
------------ -------------
00d 00:00:03 0
Console#
show interfaces status
This command displays the status for an interface.
Syntax
show interfaces status
[interface]
interface
ethernet
unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-10/28)
port-channel
channel-id (Range: 1-8)
vlan
vlan-id (Range: 1-4094)
Default Setting
Shows the status for all interfaces.
Command Mode
Normal Exec, Privileged Exec
Command Usage
If no interface is specified, information on all interfaces is displayed.
Example
Console#show interfaces status ethernet 1/1
Information of Eth 1/1
Basic Information:
Port Type : 1000BASE-T
MAC Address : 00-E0-0C-00-00-FE
Configuration:
Name :
Port Admin : Up
Speed-duplex : Auto
Capabilities : 10half, 10full, 100half, 100full, 1000full
Broadcast Storm : Enabled
Broadcast Storm Limit : 500 packets/second
Multicast Storm : Disabled
Multicast Storm Limit : 500 packets/second
Unknown Unicast Storm : Disabled
Unknown Unicast Storm Limit : 500 packets/second
Flow Control : Disabled
LACP : Disabled
MAC Learning : Enabled
Link-up-down Trap : Enabled
Current Status:
Link Status : Up
Port Operation Status : Up
To Next Page
Loading...
