Chapter 4
| System Management Commands
System Status
– 88 –
hostname
This command specifies or modifies the host name for this device. Use the
no
form
to restore the default host name.
Syntax
hostname
name
no hostname
name - The name of this host. (Maximum length: 255 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
â—†
The host name specified by this command is displayed by the show system
command and on the Show > System web page.
â—†
This command and the prompt command can be used to set the command line
prompt as shown in the example below. Using the
no
form of either command
will restore the default command line prompt.
Example
Console(config)#hostname RD#1
Console(config)#
System Status
This section describes commands used to display system information.
Table 10: System Status Commands
Command Function Mode
show access-list
tcam-utilization
Shows utilization parameters for TCAM PE
show memory Shows memory utilization parameters PE
show process cpu Shows CPU utilization parameters PE
show process cpu guard Shows the CPU utilization watermark and threshold NE
show process cpu task Shows CPU utilization per process PE
show running-config Displays the configuration data currently in use PE
show startup-config Displays the contents of the configuration file (stored in
flash memory) that is used to start up the system
PE
show system Displays system information NE, PE
To Next Page
Loading...
Need help?
General