Chapter 3
| General Commands
– 84 –
disable
This command returns to Normal Exec mode from privileged mode. In normal
access mode, you can only display basic information on the switch's configuration
or Ethernet statistics. To gain access to all commands, you must use the privileged
mode. See “Understanding Command Modes” on page 72.
Default Setting
None
Command Mode
Privileged Exec
Command Usage
The “>” character is appended to the end of the prompt to indicate that the system
is in normal access mode.
Example
Console#disable
Console>
Related Commands
enable (81)
reload
(Privileged Exec)
This command restarts the system.
Note:
When the system is restarted, it will always run the Power-On Self-Test. It will
also retain all configuration information stored in non-volatile memory by the copy
running-config startup-config command.
Default Setting
None
Command Mode
Privileged Exec
Command Usage
This command resets the entire system.
Example
This example shows how to reset the switch:
Console#reload
System will be restarted, continue <y/n>? y
To Next Page
Loading...
Need help?
General