Chapter 28
| IP Routing Commands
Global Routing Configuration
– 690 –
IPv4 Commands
ip route
This command configures static routes. Use the
no
form to remove static routes.
Syntax
ip route
destination-ip netmask next-hop [distance]
no ip route
{destination-ip netmask next-hop |
*
}
destination-ip – IP address of the destination network, subnetwork, or host.
netmask - Network mask for the associated IP subnet. This mask identifies
the host address bits used for routing to specific subnets.
next-hop – IP address of the next hop router used for this route.
distance – An administrative distance indicating that this route can be
overridden by dynamic routing information if the distance of the dynamic
route is less than that configured for the static route. Note that the default
administrative distance used by the dynamic unicast routing protocol is
120 for RIP. (Range: 1-255, Default: 1)
*
– Removes all static routing table entries.
Default Setting
No static routes are configured.
Command Mode
Global Configuration
Command Usage
â—†
Up to 56 static routes can be configured.
â—†
If an administrative distance is defined for a static route, and the same
destination can be reached through a dynamic route at a lower administration
distance, then the dynamic route will be used.
Example
This example forwards all traffic for subnet 192.168.1.0 to the gateway router
192.168.5.254, using the default metric of 1.
Console(config)#ip route 192.168.1.0 255.255.255.0 192.168.5.254
Console(config)#
To Next Page
Loading...
Need help?
General