Configuring the Switch
3-4
Main Menu
Using the onboard web agent, you can define system parameters, manage and
control the switch, and all its ports, or monitor network conditions. The following
table briefly describes the selections available from the web-browser interface.
Table 3-2 Switch Main Menu
Menu Description Page
STATUS 3-6
Overview Provides a basic system description, including system
name, IP address, port, trunk, and VLAN information.
3-6
Statistics Shows statistics for port and interface. 3-9
SYSTEM 3-10
Name Shows the name of the switch. 3-10
IP Settings Sets the LAN IP address, subnet mask, and gateway IP
address.
3-10
Password Changes the password. 3-12
Tools 3-13
Restore to Factory Defaults Force the switch to perform a power reset and restore
the original factory settings.
3-13
Upgrade Firmware Upgrade the switch system firmware using a file
provided by Edgecore.
3-13
Upload/Download
Configuration
Uploads or downloads the configuration file. 3-14
Restart Restarts the switch. 3-14
PORTS 3-15
Settings Configure the speed and duplex mode of ports. 3-15
Storm Control Sets the broadcast storm control parameters. 3-17
Port Mirroring Sets up the port mirroring features of the switch to
enable traffic monitoring.
3-18
Cable Diagnostic Diagnoses cable faults. 3-19
TRUNKS 3-19
Membership Selects ports to group into static trunks. 3-21
Settings Configures trunk connection settings. 3-21
LACP Setup Configures Link Aggregation Control Protocol (LACP)
on the switch.
3-21
LACP Status Shows the LACP groups status. 3-23
To Next Page
Loading...
Need help?
General