93
support@edgeovens.com
Technical Support: +1 (724) 628 3050
OPERATION
PREVENTATIVE MAINTENANCE
FIGURE 3-13
FREQUENCY:
Loose debris removal from the nger panel outer plates should occur MONTHLY or as
needed. Full nger assembly removal and a thorough deep clean should occur SEMI-
ANNUALLY or as needed.
METHOD:
• Remove the oven conveyor belt and nger panel assemblies from the oven chamber, see CONVEYOR
BELT & FINGER PANEL REMOVAL AND INSPECTION in the OVEN OPERATION section for further
details of how to do this.
• Use a stiff bristle brush to remove debris from the top and bottom nger outer plates.
• Use a solution of mild dish detergent and warm water for normal cleaning if required.
• Wipe the surface with a dampened soft cloth.
• If the nger assemblies have been removed from the oven, ensure they are dry before replacing them in
the order they were removed.
CAUTION:
• DO NOT apply solvents of any kind to the COLUMNATING PANEL.
• Solvents and pressure washing may be used to clean FINGER HOUSING and FINGER COVERS only.
AREA OF OVEN:
• Inside the oven cooking chamber.
CLEAN FINGER PANEL ASSEMBLIES
FIGURE 3-14
18030
FIGURE 3-12
To Next Page
Loading...
