Edgewater Networks 388CC - Fueling; Fuel System Maintenance; Fuel Filters; Chapter 5 Electrical System

13
4.4 Fueling
Before fueling, you should follow these procedures:
Make sure the boat is securely moored and engines are turned off.
Make sure all switches are off and all cigarettes and open flames are extinguished.
Know the location of all fire extinguishers.
Remove the fuel fill cap.
Place the nozzle firm against the side of the opening to prevent static discharge
Begin fueling.
DO NOT OVERFILL.
Re-install the fuel cap.
Check the bilge area for fuel odors.
Warning: If fuel odors are detected, do not start the engines! Check to make certain there
are no leaks or system problems before starting the engines.
Warning: Do not fill the fuel tank while the engines are running. Do not allow smoking or
open flames within 50 ft. of the fueling area. Fuel is very flammable. To prevent damage to
the engines, use only fuels without harsh additives or alcohol. Refer to your engine
owner’s manual for specific fuel requirements.
4.5 Fuel System Maintenance
Regularly inspect the fuel system components. All lines, fittings, and bulbs should be flexible
and not corroded. If fittings or other components are found to have cracks, they should be
replaced at once. If you use your boat infrequently or do not use it for an extended period of time,
a fuel conditioner should be added to a full tank of fuel to prevent fuel deterioration and damage to
the fuel system.
4.6 Fuel Filters
Fuel filters are installed inside the mechanical access space on the starboard-side wall. These
are fuel/water separator type of filters and are designed to prevent water from entering your
engine. The fuel filter element is a spin-off type element. At a minimum, this element should be
replaced at the beginning of every boating season. Always carry a filter wrench and spare filter of
the type supplied on your boat.
5/Electrical Systems
5.1 General
Your EdgeWater 388CC operates on a 12volt DC system, similar to your automobile. The
batteries, (2 standard plus 1 per engine), are typically lead acid type and require similar
maintenance to your automobile’s battery. A standard battery isolator and all batteries are located
inside the console, behind the access door located on the aft wall of the console.