Edgewater Networks 388CC - Waste System; Raw Water System Maintenance

16
When activated, the pump’s pressure switch will automatically control the pump. It is normal for
the pump to cycle on and off in response to flow rates and water demand.
Always turn off the freshwater pump switch when leaving the boat unattended.
Operating instructions for the freshwater system
1. Fill holding tank with drinkable water, using water fill located on the starboard side
gunwale.
2. Turn on freshwater pump switch, located on the dash switch panel.
3. Utilize all freshwater equipment. (Transom shower STD)
4. If the system has not been used for a while please allow a few minutes for the pump
to prime up. (In some cases it may take up to ten minutes to prime the system.)
Troubleshooting tips
1. You can hear the pump running, but no water is coming out of the spray head.
a. The holding tank is empty, fill with water.
b. The pump has not yet primed, hold hand over nozzle while squeezing the
trigger. This will help to prime the pump.
2. The pump will not run at all.
a. Check the breaker on the dash switch panel.
b. Make sure the battery switches are in the “ON” position.
c. Check the connections at the switch and at the pump itself.
6.5 Waste System
The waste system is comprised of a toilet and a self-contained waste unit, which has the tank,
pump and y-valve installed together and mounted in the space forward of the water tank, behind
the console storage drawer unit located on the lower forward wall. A water solenoid is also
installed above the water tank for toilet pressure regulation. The waste discharge switch on the
helm switch panel controls the unit. The system can be emptied through a deck plate located on
the starboard side deck amidships or by opening the overboard discharge valve located behind
the access doors at the rear of the console interior. The waste discharge switch should be turned
on immediately prior to use and turned off when not in use. When activated, the pump’s pressure
switch will automatically control the unit.
Please refer to your toilet and waste systems owners’
manuals for further operational procedures on the units
.
Always turn off the waste discharge switch when leaving the boat unattended.
6.6 Raw Water System Maintenance
The following checks should be made periodically to assure your system operates properly:
 Periodically spray pumps with a protective silicone solvent to reduce corrosion.
 In-line filters should be cleaned periodically to remove any collected debris.
 Fishboxes and livewells should be drained and cleaned after each use.
 Hoses and connections should be checked periodically for signs of deterioration.