Power Assist for SeaStar Systems
11
Hose connection is as follows.
• Autopilot pump MUST be connected to the steering lines AFTER
the P/A (see diagram below). The return R line MUST be tee'd
into the system in front of the P/A unit (see diagram below).
• Refer to page 6 through page 10 for you cylinder application.
• When bleeding, ensure that the autopilot Reservoir line is bled
free of air at the same time the Power Assist Reservoir line is
bled free of air. Autopilot pump must be run in both directions
during the bleeding procedure, refer to page 18 for details.
Autopilot Connection Detail
SYSTEM INSTALLATION
SEASTAR POWER ASSIST
Installation and operation can be
simplified with the purchase of a
SeaStar AutoPilot Pump. Contact
Teleflex Marine for details.
NOTICE
H1 H2
C1
C2
P
R
R
S
P
R
S
AUTOPILOT
PUMP
Hoses MUST be at least 6' in
length from the power assist to
the helm pump, or, from the
power assist to the cylinder(s).
NOTICE
Figure 8.
DO NOT run the wires or hoses
in areas where the may come
in contact with battery acid or
excessive heat, i.e. engine
exhaust, manifolds or any
other area that may damage
the wires or hoses.
WARNING
To Next Page