Power Assist for SeaStar Systems
17
FILLING AND PURGING
SEASTAR POWER ASSIST
Step 3
TURN COUNTER-
CLOCKWISE
CLOSE RIGHT
SIDE BLEEDER
CLOSE LEFT SIDE
BLEEDER
TURN COUNTER-
CLOCKWISE
• Holding the cylinder body (Front Mount cylinder) or rod (Side
Mount cylinder) to prevent the body/rod from moving, turn the
steering wheel counter-clockwise until a steady stream of air free
oil comes out of the bleeder. (Drain approx. 1/2 bottle of oil or as
required).
Do not use anything other than your hands to restrain the
cylinder body/rod.
• While continuing to turn the wheel close the bleed fitting for your
application and let go of the cylinder body/rod.
Outboard Front Mount & HC5332 Cylinder
Side Mount / Splashwell Mount Cylinder All Balanced Cylinder. Inboard & Sterndrive Cylinders
TURN COUNTER-
CLOCKWISE
CLOSE LEFT SIDE
BLEEDER
Step 4
TURN COUNTER-
CLOCKWISE
OPEN LEFT
SIDE BLEEDER
OPEN
RIGHT
SIDE
BLEEDER
TURN COUNTER-
CLOCKWISE
• Continue turning the steering wheel counter-clockwise until the cylinder
rod is fully extended to the left. (Steering wheel will come to a stop).
• Open bleed fitting as per your installation.
Outboard Front Mount & HC5332 Cylinder Side Mount / Splashwell Mount Cylinder All Balanced Cylinder. Inboard & Sterndrive Cylinders
TURN COUNTER-
CLOCKWISE
OPEN
RIGHT
SIDE
BLEEDER
To Next Page