Power Assist for SeaStar Systems
19
FILLING AND PURGING
SEASTAR POWER ASSIST
Perform Steps 1 – 6 at station
no. 1. Then repeat Steps 2 – 5
at station no. 2.
Note: Refer to Oil Level &
System Check on page 20.
Twin Station Single Cylinder
STATION NO.2
STATION NO.1
CYLINDER
P/A UNIT
Follow same procedure as
instructed for single station-twin
cylinders, beginning at station
no. 1, and repeat entire
procedure at station no. 2.
Note: Refer to Oil Level &
System Check on page 20.
Twin Station Twin Cylinder
CYLINDER NO.2 CYLINDER NO.1
STATION NO.2
STATION NO.1
CYLINDER NO.2
CYLINDER NO.1
When performing Steps 2 – 5,
perform instructions in each
step first on cylinder no. 1 and
then on cylinder no. 2, before
proceeding to the next step. ie:
Perform instructions referring
to right side of cylinder first on
cylinder no. 1 and then on
cylinder no. 2.
Note: Refer to Oil Level &
System Check on page 20.
Single Station Twin Cylinder
P/A UNIT
P/A UNIT
To Next Page