35
Authentication Select the wireless authentication here, and this setting
must be the same with the wireless access point you
selected.
When you select a wireless access point from the list, it’s
authentication type will be selected automatically, and
you should not modify it or you will not be able to connect
to the wireless access point you selected.
Available options are: None (no authentication), Open
System, Shared Key System, WPA-PSK, WPA2-PSK,
and WPANone (the last one is only for Adhoc).
Encryption Type Select the wireless encryption type here, and this setting
must be the same with the wireless access point you
selected.
When you select a wireless access point from the list, it’s
encryption type will be selected automatically, and you
should not modify it or you will not be able to connect to
the wireless access point you selected.
Available options are: None, WEP, TKIP and AES. The
options available here will vary depends on the
authentication type you selected above. If an
authentication type does not support need encryption,
this field will be grayed out.
WPA Pre-Shared
Key
Input the WPA pre-shared key here.
This field is only available when authentication type is
WPA-PSK or WPA2-PSK, and will be grayed out when
other authentication type is selected.
WEP Key Length Please select the key length when you use WEP
encryption. Available options are 64-bit and 128-bit.
Selecting ‘128-Bit’ is safer, however, it would make the
network a little bit slower.
To Next Page
Loading...
