70
Encryption Type: Select the encryption type required by
the network device you wish to connect here, the content
of drop down menu will vary depend on the authentication
type you selected above.
WPA Pre-Shared Key: Input the WPA pre-shared key of
the wireless device you wish to connect here. Must be the
same with the setting of the wireless device you wish to
connect, or you’ll not be able to build connection. This
option will be grayed out when encryption type is not WPA.
Key Length: Select the key length of WEP encryption. Must
be the same with the setting of the wireless device you
wish to connect.
Key Format: Key Length: Select the key format of WEP
encryption. Must be the same with the setting of the
wireless device you wish to connect.
Default Key: Select the default encryption key of WEP
encryption. Available options are Key 1 to Key 4; in most
cases you should use Key 1, unless otherwise instructed.
Key 1 to Key 4: Input the WEP encryption key here in
respective field. In most cases only Key 1 is required.
When you finish with setting, click ‘OK’ to save settings.
Edit You can edit the content of a selected profile.
Delete You can delete a selected profile. You WILL NOT be
prompted before deleting a profile, use with caution.
Activate Activate selected profile (connect to the wireless device
defined in the profile).
After all settings are completed, click ‘OK’ to save settings, or click ‘Cancel’ to abort
and discard changes.
To Next Page
Loading...
