DCP 350 User Manual
2.5.3 Network module management
Pic.57 USB port state
“USB port state” shows USB device status
connected on network module.
Network module has 4 USB ports.
Network module supports PC/SC. When you
install the encoders that support PC/SC on
network module, you can recognize the status
of encoders.
Pic.58 Rebooting the network module
“Reboot module” reboots network module.
Please click “Yes” when pop-up window comes
out for reboot.
It takes 1 minute to reboot.
Please click “Refresh” after reboot. When
proper printer shown, please connect printer by
clicking “Connect”.
To Next Page
Loading...
