DCP 350
⑤ To set print area. Please set it properly to print on an entire card because the EDIsecure
®
DCP
350 is a direct thermal card printer. When you click “⑦ Print”, a card is printed as like “④
example”. Please set values properly that all circles of each corner are printed and blank
spaces are 0.4mm ~ 0.5mm in the top and the bottom of a card. Please set values by following
order.
X Start Position: Please set right and left properly by adjusting X position.
Y Start Position: Please set the start position of printed example image and blank space in
the top is 0.4mm ~ 0.5mm.
Y End Position: Please set the end position of printed example image and blank space in the
bottom is 0.4mm ~ 0.5mm. It is recommended to set bigger value for “Y scale” than
default.
Y Scale: Please set to show circles in the bottom.
⑥ To set density. The EDIsecure
®
DCP 350 enables to set different density for each color, resin
black and overlay. So, please set each density for high quality. Please optimize the quality by
adjusting each value. To optimize, you repeatedly adjust the density and print a Calibration
card and check the print state until you get the optimum.
Total Density: To set all of the density (Color, Black and Overlay) at one time.
YMC Density: To set color density. Please maximize YMC density as you can, which enables
to express range of color and vivid images. If it is too strong, green or red marks appear. If it is
too weak, the print quality will be dull. (Please refer Pic.103.)
Pic.77 Color density
To Next Page
Loading...
