ES-10B 4 Terminal Single Phase Residential Electricity
Meter - Product Guide
Copyright © 2019 EDMI Europe Ltd. All rights reserved
Version / Status: 1.1
Public
9 Inside the Meter
Note: The meter is not designed to be opened after manufacture unless in an EDMI approved
triage centre.
Care must be taken as dangerous voltages are present in the circuitry inside the meter while the
meter is active. Even when the meter is not powered, care should be taken to prevent electrostatic
damage to the circuitry of the meter.
During the normal operational life of the meter there is no reason to remove the meter cover. The
tamper evident seals restrict access to the screws which hold the meter lid closed. Only by
permanently breaking them will the screws become accessible and the meter case can be opened.
The screws underneath the seals enable the main meter lid to be removed. Any attempt to remove
the main cover will trigger a 2
nd
physical tamper alert to be logged in the meter and sent via the
HAN.
Any issues with metering products should be referred to EDMI through the RMA procedure.
To Next Page
Loading...
