Edwards EST4 - Finding Firmware and System Information; Revision Report

Chapter 2: Basic operating instructions
P/N 3102309-EN • REV 001 • ISS 18JUL19 25
To view history reports:
1. On the Action bar, tap System Info.
2. On the Command bar, tap the desired history report button. The report displays on the screen.
Tap the print button
⎙ to send the report to a local printer.
Finding firmware and system information
The EST4 control unit provides revision and system information reports where you can find unit database,
firmware, and project versions, device firmware numbers, MAC addresses, and other system information.
Revision report
The Revision report provides system database information and installed hardware information. The hardware that
shows on the list is dependent on the devices installed in the control unit cabinet.
By viewing a Revision report, you can find information for the following:
• Alarm history count: Shows the total number of times that the control unit has gone into alarm since the alarm
history was cleared.
• Market: Shows the 4-CU market setting.
• Configuration version: Shows the 4-CU project version number.
• Configuration time stamp: Shows the date and time that the 4-CU project was created or modified.
• Configuration schema: Shows the 4-CU firmware-to-software interface version.
• Configuration messaging: Shows the 4-CU internal messaging protocol version.
• Firmware: Shows the 4-CU firmware version.
• Local rail module (LRM) shows:
– LRM type
– Firmware version and date
– Bootloader version and date
– 4-CU database version and date
• Control-display module (CDM) Annunciator shows:
– CDM type
– Firmware version and date
• CPU shows:
– CPU type
– Firmware version and date
– Bootloader version and date.
To view the Revision report:
1. On the Action bar, tap System Info.
2. On the Command bar, tap the Revision button. The Revision report displays on the screen.
Tap the print button
⎙ to send the report to a local printer.