Chapter 3: Advanced operating instructions
P/N 3102309-EN • REV 001 • ISS 18JUL19 41
Disabling and enabling control-display modules
Disabling a control-display module isolates it from the system. While disabled, changes to the module’s state are
not processed. Enabling a control-display module re-establishes it as part of the system. When enabled, any
changes in state that occurred while the module was disabled are not processed.
Note: Only users with fire privilege 3 can access this function.
To disable a control-display module:
1. Sign in with fire privilege 3 or higher, and then tap Project Tree on the Action bar.
2. Expand the project tree by tapping the expand button , and then locate the target control-display module.
3. Tap the control-display module, and then tap Disable on the Command bar.
To enable a control-display module:
1. Sign in with fire privilege 3 or higher, and then tap Project Tree on the Action bar.
2. Expand the project tree by tapping the expand button , and then locate the target control-display module.
3. Tap the control-display module, and then tap Enable on the Command bar.
Disabling and enabling control-display module elements
Disabling and enabling control-display module switches
Note: Only users with fire privilege 3 can access this function.
To disable a control-display module switch:
1. Sign in with fire privilege 3 or higher, and then tap Project Tree on the Action bar.
2. Expand the project tree by tapping the expand button , and then locate the target switch.
3. Tap the switch, and then tap Disable on the Command bar.
To enable a control-display module switch:
1. Sign in with fire privilege 3 or higher, and then tap Project Tree on the Action bar.
2. Expand the project tree by tapping the expand button , and then locate the target switch.
3. Tap the switch, and then tap Enable on the Command bar.
Disabling and enabling control-display module LEDs
Note: Only users with fire privilege 3 can access this function.
To disable a control-display module LED:
1. Sign in with fire privilege 3 or higher, and then tap Project Tree on the Action bar.
2. Expand the project tree by tapping the expand button , and then locate the target LED indicator.
3. Tap the LED indicator, and then tap Off on the Command bar.
To enable a control-display module LED:
1. Sign in with fire privilege 3 or higher, and then tap Project Tree on the Action bar.
2. Expand the project tree by tapping the expand button , and then locate the target LED indicator.
3. Tap the LED indicator, and then tap On on the Command bar.
To Next Page
Loading...