Chapter 3: Advanced operating instructions
42 P/N 3102309-EN • REV 001 • ISS 18JUL19
Setting a control-display LED module mode
Note: Only users with fire privilege 3 can access this function.
To set a control-display module LED mode:
1. Sign in with fire privilege 3 or higher, and then tap Project Tree on the Action bar.
2. Expand the project tree by tapping the expand button , and then locate the target LED indicator.
3. Tap the LED indicator, and then tap one of the following: Steady, Fast Blink, Slow Blink, Off.
To Next Page
Loading...
