Chapter 3: Advanced operating instructions
38 P/N 3102309-EN • REV 001 • ISS 18JUL19
• Disabling all of the devices in a zone group automatically disables the zone group. Enabling any device in the
zone group automatically enables the zone group.
• When you enable a device, all indicators and outputs activated by the device will reactivate.
• Only users with fire privilege 3 can access this function.
To disable a device:
1. Sign in with fire privilege 3, and then tap Project Tree on the Action bar.
2. Expand the project tree by tapping the expand button , and then locate the target device.
3. Tap the device, and then tap Disable on the Command bar.
To enable a device:
1. Sign in with fire privilege 3, and then tap Project Tree on the Action bar.
2. Expand the project tree by tapping the expand button , and then locate the target device.
3. Tap the device, and then tap Enable on the Command bar. You must enable the device the same number of
times that you disabled it. If necessary, view the Status Disabled report to see the manual disable counter
(Action Bar > System Info > Status Disabled).
Disabling and enabling local rail modules
Local rail modules can include chassis rail cards and modules installed on the backbox, and control-display
modules installed on the inner door. Disabling a module isolates it from the system. While the module is disabled,
the EST4 control unit logs the status change signals, but is prevented from processing the signals until the
module is enabled.
Notes
• The control unit keeps track of how many times you disable a module without enabling it. You must enable a
module the same number of times you disable it in order to return the module to its original condition. The
Status Disabled report provides a counter that shows the number of times the device was manually disabled.
• Only users with fire privilege 3 can access this function.
To disable an LRM:
1. Sign in with fire privilege 3, and then tap Project Tree on the Action bar.
2. Expand the project tree by tapping the expand button , and then locate the target LRM.
3. Tap the module, and then tap Disable on the Command bar.
To enable an LRM:
1. Sign in with fire privilege 3, and then tap Project Tree on the Action bar.
2. Expand the project tree by tapping the expand button , and then locate the target LRM.
3. Tap the module, and then tap Enable on the Command bar. You must enable the device the same number of
times that you disabled it. If necessary, view the Status Disabled report to see the manual disable counter
(Action Bar > System Info > Status Disabled).
To Next Page
Loading...
