Chapter 2: Basic operating instructions
26 P/N 3102309-EN • REV 001 • ISS 18JUL19
System information report
The System Info report provides a project description that includes the control unit (node) MAC address required
for communication between the 4-CU and control unit, and project versioning numbers. Component licensing and
copyright information is also included in the report.
By viewing the System Info report, you can find information for the following:
Project Description
• IP/DNS node name: Shows the MAC address of the installed CPU.
Versions
• Configuration Utility: Shows the 4-CU software version.
• Project Configuration: Shows the 4-CU project version number.
• Project Configuration Date: Shows the date and time that the database was downloaded.
• Project Configuration ID: Shows the database serial number created when the database was converted.
• Configuration schema: Shows the 4-CU software-to-firmware interface version.
• Message Schema: Shows the 4-CU internal messaging protocol version.
• Firmware: Shows the 4-CU firmware version.
• Archive Enabled: Shows whether the project is configured to automatically archive project files.
Licensing
• Licensing and copyright information for various components used in the 4-CU software and firmware.
To view the System Information report:
1. On the Action bar, tap System Info. The System Information report displays on the screen.
Tap the print button
⎙ to send the report to a local printer.
Obtaining an access code for a system programmer
A system programmer downloads firmware and project databases to the control unit from a computer running the
system configuration utility. By default, the control unit is blocked from allowing unauthorized database changes.
The programmer may request that you obtain a control unit access code to gain access for a system download.
Note: The access code should only be used by a system programmer or service provider. Changes to the life
safety system must be tested and may require local authority approval.
To obtain an access code:
1. On the Action bar, tap System Info.
2. On the Command bar, tap 1 Hour Access or 8 Hour Access. A 6-digit access code displays.
To cancel access:
1. On the Action bar, tap System Info.
2. On the Command bar, tap Cancel Access.
To Next Page
Loading...