SERVICING THE E-43A WITH FURNITURE 122
REPLACING THE E-43A IN THE FURNITURE
1 Make sure that the left side panel is removed from the E-43A.
2 Place the E-43A upright on the furniture stand. Slide the E-43A forward just until its front
panel is aligned with the back edge of the table top.
Use the handle on the stability bracket to lift the rear of the E-43A and slide it forward.
3 Route the monitor cables (power and video) into the cutout in the back of the top panel. Pull
each cable out of the cutout in the top panel.
Video cable
Power cable
Top cutout
Back cutout
Top panel
To Next Page
Loading...
