REPLACING PARTS 66
TO REPLACE A DIMM
1 Shut down, and then open the E-43A (see pages 43 and 44).
To access the DIMMs, you must remove the left panel.
2 To release a DIMM, push outward on the levers on each side of the DIMM.
3 Pull the DIMM straight out of the socket.
4 To replace a DIMM, insert the DIMM straight into the socket and close the levers at each side
to lock it into place.
NOTE: The socket is keyed so that the DIMM fits only one way. (See the notches in the
preceding figure.)
Make sure that the entire length of the DIMM (ends and center) is fully seated in the socket
and that the levers close securely around the ends of the DIMM.
5 If you installed a new DIMM, make sure to reset the time and date in Setup (see Configure
Help for more information).
6 Reassemble the E-43A and verify its functionality (see page 86).
CPU
The CPU is installed in a socket on the motherboard. Before you remove the CPU from its
socket, remove the motherboard from the chassis (see page 56), disconnect the CPU fan cable
from the motherboard, and then remove the cooling assembly from the E-43A (see page 67).
The CPU cooling assembly consists of a fan and a heatsink.
To Next Page
Loading...
Need help?
General
