REPLACING PARTS 50
2 Connect the power/reset button cables from the front panel to the J102 connector.
FIGURE 19: J102 connector on the printer interface board
3 Connect the 10-pin power button cable from the FPIO_1 connector to the J103 connector
(see Figure 14 on page 43).
4 Reassemble the E-43A and verify its functionality (see page 86).
User interface board assembly
The user interface board (UIB) provides the interface between the E-43A and the user. The
front of the UIB contains circuitry for the following:
• Activity lights (amber, green, and red LEDs)
•Display window (LCD)
• Four line selection buttons
• Up and Down buttons
• Menu button
•Jewel lights
NOTE: The buttons are not included in the user interface board spare kit.
(Green) (Blue)
To Next Page
Loading...
