EFI E-43A - Changing the factory default language; Installing system software

SYSTEM SOFTWARE INSTALLATION 92
• Advanced backup management
Allows the Administrator to:
– Load backup settings from a USB drive to apply to system backup images.
– Save or restore backup history files.
– Search for backup images created on a replaced system to be applied to the current one.
• Launch Windows Task Manager
Starts the Windows Task Manager.
Changing the factory default language
You can change the E-43A default language using the Configure tool, available through
Command WorkStation and WebTools.
TO CHANGE THE FACTORY DEFAULT LANGUAGE
1 Open Configure through Command WorkStation or WebTools.
2 Click Fiery Server > Regional Settings and do the following:
• Clear the “Use Print Engine Language” check box.
• In the Server Language drop-down list, select a language.
3 Save your changes.
It takes approx. 15-20 minutes to change languages.
Installing system software
E-43A system software is provided on the following media:
• System Software DVDs contain the Windows operating system software and
the Fiery Server software.
• User Software DVD contains the E-43A user software.
Install system software in the following cases:
• The hard disk drive or motherboard is replaced.
• The E-43A must be updated to a more recent version of the system software.
System software installation takes approximately 45 minutes (not including the time required
to configure Setup).