REPLACING PARTS 86
Restoring and verifying functionality after service
Before you leave the customer site, make sure that you complete the following steps. If you
cannot complete a step, determine the reason and correct the problem before continuing.
For more information, see Troubleshooting on page 98.
TO REASSEMBLE THE E-43A AND VERIFY FUNCTIONALITY
1 Reseat all boards, cables, connectors, and other parts loosened or removed during service.
When routing cables inside the E-43A, make sure that:
• Covers are securely installed after routing cables
• Cable routing does not interfere with the operation of internal components nor interfere
with removing or replacing components
• Cables are not tangled nor looped around internal circuit boards or components
(such as capacitors and resistors)
• Cables do not lie on or against any internal heating element
• Cables do not interfere with opening or closing E-43A panels
• Cable slack is secured with a tie-wrap
2 Restore the E-43A to the upright position.
3 Replace any panels that you removed earlier, as described on page 44.
4 If you replaced the motherboard, make sure that the new motherboard solves the problem
that you are troubleshooting, and then transfer options to the new motherboard (see
page 64).
5 If the E-43A is to be mounted on the furniture with the monitor, see the reassembly
instructions that is provided with the furniture assembly (page 117).
6 Connect the power cable to the E-43A (see page 19).
7 Connect the E-43A to the copier/printer (see page 21).
8 Print the Test Page and Configuration page.
• If the E-43A does not start up, refer to the startup problems listed on page 105.
• If pages do not print, verify that the interface cables are properly connected (see printing
problems on page 112).
• If image quality is poor, test the copier/printer (see the service documentation that
accompanies the copier/printer).
9 Connect to the network (see page 22).
10 Ask the site administrator to download a test job over the network.
If the job does not print, or has poor image quality, see printing problems and the
Troubleshooting sections of the user documentation.
To Next Page
Loading...
Need help?
General
