EFI Fiery E300 - Mobile Device Printing; Configure Direct Mobile Printing

Mobile device printing
Direct Mobile Printing allows direct wireless printing to the E300 from supported mobile devices.
Supported mobile devices must be connected to the same wireless-network subnet as the E300 to print using Direct
Mobile Printing.
Configure Direct Mobile Printing
1 In Configure, click Security > TCP/IP Port Filtering.
2 Select Enable TCP/IP Port Filter and make sure the following ports are enabled:
• 80 (HTTP)
• 631 (IPP)
• 5353 (Multicast DNS)
• 6310 (Direct Mobile Printing)
3 Click Job Submission and make sure the following settings are enabled:
a) Click Queues and select Publish Print Queue.
b) Select IPP.
c) Click Web Services for Devices (WSD) and select Enable WSD.
d) Click Direct Mobile Printing and select Enable Direct Mobile Printing (disabled by default).
4 Click Network > Bonjour and make sure the following setting is enabled: Enable Bonjour.
Configuration and Setup
Configuring the E300 for your network and print environment
42