10 Mbps Full-Duplex
100 Mbps Full-Duplex
IP Address
Enter the E300 IP address for Ethernet.
This IP address, unlike an IP address set automatically, remains the same if you restart the E300. You must change
the default to a valid address for your network.
Settings:
127.0.0.1 (default)
Subnet Mask
Set the subnet mask for printing with TCP/IP on your network.
Note: This option is available when the IPv4 Address Type is set to Manual.
Note: Before proceeding, confirm the subnet mask setting with your network administrator.
Settings:
255.255.255.0 (default)
Gateway Address
Set the gateway address for printing with TCP/IP on your network.
Login timeout
Specify when the E300 times out after you log on.
When you finish making changes, save the changes. The E300 requires a reboot in order for any Setup changes to
take effect.
Settings:
45 seconds (default)
5 minutes
10 minutes
15 minutes
30 minutes
Never
LAN Security (802.1x)
The E300 can seek authentication from an 802.1x authentication server (such as a RADIUS server), often through an
intermediate access point (an authenticator).
The E300 seeks this authentication at startup, or when the Ethernet cable is disconnected and reconnected. If the
E300 is successfully authenticated, it is allowed access to the network.
Configuration and Setup
Accessing E300 options through the printer control panel
32
To Next Page
Loading...
Need help?
General
