Enable 802.1x Authentication
Select to allow the E300 to seek authentication from an 802.1x authentication server.
Settings:
Off (default)
On
Select EAP Type
Choose the type of EAP (Extensible Authentication Protocol).
Settings:
MD5-Challenge
PEAP-MSCHAPv2 (default)
Username
The E300 uses this information to request authentication from an 802.1x authentication server.
Use ASCII code characters (63 characters maximum). It is possible to enter more, but the supported length is 63
characters maximum. Although you can enter characters other than ASCII code characters, only ASCII code
characters are guaranteed for authentication.
Settings:
User name (default is product or site-specific)
Password
The E300 uses this information to request authentication from an 802.1x authentication server.
Note: This option is only available when Enable 802.1x Authentication on page 33 is selected.
Use ASCII code characters (63 characters maximum). It is possible to enter more, but the supported length is 63
characters maximum. Although you can enter characters other than ASCII code characters, only ASCII code
characters are guaranteed for authentication.
Settings:
Password (default is product or site-specific)
Validate Server Certificate
Select this option if you set Select EAP Type to PEAP-MSCHAPv2 and want the E300 to use a trusted root certificate
when communicating with the authentication server. If you want the E300 to validate the server certificate, place the
certificate in the list of trusted certificates of the E300.
Configuration and Setup
Accessing E300 options through the printer control panel
33
To Next Page
Loading...
Need help?
General
