31
Chapter 4
Advanced Adjustments/Settings
Function Settings Description
Indicator O
1 to 7
The brightness of the power switch and the operation
switches when the screen is displayed can be set. (Default
setting: 4)
Beep On
O
You can set the beep that sounds each time a switch is
operated.
Input Skip Skip
-
This function allows skipping of input signals that will not be
used when the input signals are switched.
Note
• Not all input signals can be set to "Skip".
Mode Skip Skip
-
This function allows skipping of modes that will not be used
when selecting modes. Please use this function if display
modes are limited, or if you want to prevent randomly
changing the display status.
Note
• Not all modes can be set to "Skip".
Custom
Key
[F1]
[F2]
O
Brightness
Prev. Color Mode
Information
You can set the function that is assigned to the [F1] or [F2]
switch.
Note
• By default, the [F1] switch is set to the "Brightness"
function and the [F2] switch is set to "Prev. Color Mode".
• Regarding the custom keys, see "Chapter 3 Custom Key
Settings" (page 19).
USB
Selection
HDMI
DisplayPort
USB-C
USB-1 (USB-C)
USB-2
When two PCs are connected to one monitor, you can link
the input signal with the USB upstream port. After linking,
the USB ports will automatically switch when the input
signals switch. When you calibrate one monitor from two
PCs, it is not necessary to switch USB cables. It is also
possible to connect USB devices such as a mouse or
keyboard to the monitor and use them from two PCs.
The default settings may dier depending on the input
signal.
Input signal Default setting
HDMI, DisplayPort USB-2
USB Type-C USB-1 (USB-C)
Note
• When you want to change settings and there is a storage
device such as USB memory connected to the monitor,
change settings only after you have removed the storage
device. In failing to do so, data may be lost or damaged.
• You cannot change the keyboard layout.
• The USB downstream port works with the PC that is
currently being displayed.
Monitor Reset OK
Cancel
Restore all settings to their default values except for the
following settings.
• Settings in the "Administrator Settings" menu
• The "USB Selection" item in the "Preferences" menu