Safety notes
2.1 General safety notes
SCD 19102 / SMD 19102
Instruction Manual, 10/2011, A5E01588521A-004
13
NOTICE
Touching the screen surface can result in brief disturbances to the image
Due to mechanical pressure or electrostatic discharging, touching the screen can result in
brief disturbances to the image.
Only switch on cold displays following their adaptation to room temperature
If the display is brought into a room with a higher or rising temperature, condensation is
formed inside and outside the unit. In such a case, do not switch on the display until the
condensation has evaporated. The display will otherwise be damaged.
What to do if the display is faulty
If the following conditions exist, the display must be disconnected from the power supply
and checked by qualified personnel:
• Damage to the plug or power cable.
• Following the entry of liquid into the unit.
• If the unit has been exposed to moisture.
• If the unit does not function or if you cannot eliminate a fault using the instruction
manual.
• If the unit has been dropped and/or the housing damaged.
• If the unit smells of burning or produces peculiar noises.
Information for installations in the USA and Canada
Molded power supply plugs must comply with the requirements for "hospital grade
attachments" CSA Std. C22.2 No. 21 and UL 498.
Note for installations in China
Only use the the power cables approved for China. These power cables are identified by
the labels "CCC" or "CQC".
See also
Installation site (Page 19)
General connection information (Page 23)
Connecting the signal cables (Page 27)
Connecting the line cord (Page 29)
Serial interface (Page 34)
Cleaning (Page 85)
Safety specifications (Page 94)
To Next Page
Loading...
