Safety notes
2.2 Product-specific safety notes
SCD 19102 / SMD 19102
14 Instruction Manual, 10/2011, A5E01588521A-004
2.2 Product-specific safety notes
DANGER
If the SCD / SMD 19102 is mounted on a stand:
Adjust the display height carefully, otherwise danger of injury
When adjusting the height of the display, make sure that you do not trap your fingers or any
other objects.
CAUTION
Notes on installation
The stability of the display must be ensured following mounting of the stand/holder. The
insertion depth of the mounting screws into the display must be between 7 and 9 mm.
Subsequent mounting of a stand
The SCD / SMD 19102 C and SCD / SMD 19102 CP displays are delivered without a
stand. To ensure that the complete system (display and stand) complies with the EN 60601
standard, a subsequently mounted stand must also comply with the EN 60601 standard.
See also
Mounting of unit (Page 21)
Installing/removing the display stand a
nd cable for the SCD 19102 (Page 30)
To Next Page
Loading...
