Electrolux OVC3000 - Page 38

Technical Support - BSP 38/47 599 73 09-98 Rev. 02
DISPLAY
CODE
DESCRIPTION
TROUBLESHOOTING
C1 (*)
Tele run at pyro function:
If telescopic runner is insert no pyro function possible.
Power board OC goes in PYRO_SAFE_STATE and send this
state in the oven control status message and no heating
elements are on.
User interface OUI has to display C1 or a text information in
text line or in a pop up window. If the error is reset, the OUI
goes in standby and set the OC in standby too.
Before you activate the pyro
function remove the telescopic
runners from oven.
C2 (*)
Meat probe at pyro function:
If Meat probe is insert no pyro function possible.
Power board OC goes in PYRO_SAFE_STATE and send this
state in the oven control status message and no heating
elements are on.
User interface OUI has to display C2 or a text information in
text line or in a pop up window. If the error is reset, the OUI
goes in standby and set the OC in standby too.
Before you activate the pyro
function remove the Meat
probe from oven.
C3 (*)
Opened door at pyro function:
If door is open no pyro function possible.
Power board OC goes in PYRO_SAFE_STATE and send this
state in the oven control status message and no heating
elements are on.
User interface OUI has to display C3 or a text information in
text line or in a pop up window. If the error is reset, the OUI
goes in standby and set the OC in standby too.
Before you activate the pyro
function close the oven door.
(*) This code is dependent from the user interfaces in some the indication is textual (see documentation for
the interface).