Service
Manual
23
23. Programme unit
34
438 9145-41/03
03.11
1 2 3
4 5 6
7 8 9
0
1 2 3
4 5 6
7 8 9
0
Water level after unbalance halt
Here you determine the water level to which the
machine fills after a halt in extraction due to
unbalance.
If the machine’s unbalance-sensing equipment is
activated when extraction begins, that extraction
will halt and a new attempt will begin. If you want
the drum to be filled with water to a certain level
before the drain valve opens and the machine
makes a fresh attempt at extraction, you can set
that level here. Level 0 means that the drum will
not fill.
For information on the levels used for the various
machines, see the manual ”Programming, PCS
Program Control Unit”.
MACHINE NOT HEATED N
TEMPERATURE CONTROL OF WATER Y
TEMPERATURE IN °CY
REPEAT PROGR. MODE QUESTION N
LOCKED STANDARD WASH PROGRAMS N
LEVEL QUICK COOL-DOWN 175
LEVEL UNBALANCE 0
LEVEL LOW 135
LEVEL MEDIUM 150
LEVEL HIGH 175
MIDDLE TEMPERATURE COOL-DOWN 70 °C
DEFAULT MOTOR ON TIME 0:12
DEFAULT MOTOR OFF TIME 0:03
FLUSH DELAY TIME 0:06
FLUSH ON TIME 0:10
Use the numeric keys to
enter the value.
If you make a mistake while
entering digits:
Press ERASE.
When you have finished:
Press .
Low / Medium / High levels
Here you determine the water levels which are to
correspond to L (low), M (medium) and H (high).
These levels are used when you are programming
in Standard mode.
For information on the levels used for the various
machines, see the manual ”Programming, PCS
Program Control Unit”.
TEMPERATURE IN °CY
REPEAT PROGR. MODE QUESTION N
LOCKED STANDARD WASH PROGRAMS N
LEVEL QUICK COOL-DOWN 175
LEVEL UNBALANCE 0
LEVEL LOW 135
LEVEL MEDIUM 150
LEVEL HIGH 175
MIDDLE TEMPERATURE COOL-DOWN 70 °C
DEFAULT MOTOR ON TIME 0:12
DEFAULT MOTOR OFF TIME 0:03
FLUSH DELAY TIME 0:06
FLUSH ON TIME 0:10
BUZZER ON BUTTON Y
MAX FILLING TIME 10:00
Use the numeric keys to
enter the value.
If you make a mistake while
entering digits:
Press ERASE.
When you have finished:
Press .