Electronics Line iconnect - Page 34

6. Telecontrol
28
iConnect User Manual

Do not enter your user code until you hear the two tones. Any digits entered 
beforethetonesaresoundedaredisregardedbythesystem.
3. Atoneissoundedtoindicatethatthesystemisreadytoreceivecommands.
Thefollowingcommandsareavailableforunpartitionedsystems:
 Press“2”forTwo‐WayAudio.
IftheTWAmodeisdefinedas“Simplex”(seep.29, 6.5.
SimplexMode),theaudiochannelopensinListenmode
(microphoneactive/speakermute).ToswitchtoSpeakmode,
press“1”onyourtelephone.ToswitchbacktoListenmode,
press“0”onyourtelephone.
During the TWA session, you can adjust the speaker
volumeusingthearrow buttons.
 Press“3”tofullyarmthesystem.
 Pressʺ4XXʺtoturnHAunit#XXON.
 Pressʺ430ʺtoactivatePGMoutput(Unit30)
 Pressʺ5XXʺtoturnHAunit#XXOFF.
 Pressʺ530ʺtodeactivatePGMoutput(Unit30)
 Press“6”todisarmthesystem.
 Press“9”tocancelthesiren.
Forpartitionedsystems,arminganddisarmingcommandsaredifferent:
 Press“31”tofullyarmthesystem.
 Pressʺ32ʺtoarmpartition1.
 Pressʺ33ʺtoarmpartition2.
 Press“61”todisarmtheentiresystem.
 Pressʺ62ʺtodisarmpartition1.
 Pressʺ63ʺtodisarmpartition2.
The Arm/Disarm, Home Automation/PGM on/off, and
Sirencancelingcanalsobeexecutedatanytimeduringa
Two‐WayAudiosession.
Error beeps (three tones) sound in case of a wrong
command.
Toclearthelastcommand,press“@”or“#”.
4. Thedurationofthecallisanoption
programmedbyyourinstaller.Ten
secondsbeforetheendofthecall,twoshorttonesaresounded.Toextend
thecall,press“7”onyourtelephone.
5. Todisconnectbeforetheendofthecall,press“@”then“#”onyourtelephone. 
