6. Telecontrol
iConnect User Manual
29
Siren Muting
The siren is muted during Two‐Way Audio communication. At the end of the call, the
siren is re‐activated (if the Siren Cut‐Off has not yet expired). You can cancel the re‐
activationofthesirenbypressing“9”onyourtelephoneduringthecall.
6.2. Service Call
TheServiceCallfeatureenablesyoutocallthemonitoringservice.
TomakeaServiceCall:
Pressandholddowntheuparrowbutton andthenpressand
holdServiceCallbutton
forafewseconds.
If using Simplex mode, the call is connected in Listen mode – see p. 29,
6.5.
SimplexMode.
6.3. Two-Way Audio after an Alarm
In the event of Burglary, Fire and Medical alarms, the Control System is able to report
the events and then stay on the line. This allows the monitoring service to verify the
alarmorprovideassistanceintheeventofanemergency.
6.4. Two-Way Audio Follow-Me
This feature causesthe Control Systemto call you in the event of an alarm sothatyou
maycheckyourfamilyandhome.
When the Control System calls, you will hear two short tones when you pick up the
phone.Pressʺ2ʺonyourtelephonetoanswerthecall.
If you press “9” to answer the call, the Control System simultaneously cancels
thesirenwhenyouanswerthecall.
If using Simplex mode, the call is connected in Listen mode – see p. 29,
6.5.
SimplexMode.
6.5. Simplex Mode
It is possible that the Two‐Way Audio features on your system are programmed to
operate in “Simplex” mode. Simplex mode means that one party may speak while the
otherpartylistens.
If using Simplex mode, the call is connected in Listen mode. In Listen mode, the
microphoneontheControl
Systemisturnedonsothatyoucanlistenin.Ifyouwantto
switchtoSpeakmode,press“1”onyourtelephone.
In Speak mode, the microphone is turned off and the speaker is turned on so that you
canspeaktothepersonontheotherend
oftheline.IfyouwanttoswitchbacktoListen
mode,press“0”onyourtelephone.
To Next Page
Loading...
