3. Arming and Disarming
iConnect User Manual
21
The system may be programmed to display arm status at all times or only for
thefirsttwominutesor30secondsafteryouarmordisarmthesystem.
In addition to arm status, the system displays messages on statuses that may prevent
youfromarmingyoursystem(seethe
followingtable):
Status Meaning
ZONES IN ALARM Zones have been violated.
TAMPER ALARM The system has been tampered with.
SYSTEM NOT READY The system is not ready to arm, check that all doors and
windows are closed.
KEYPAD LOCKED Five unsuccessful attempts were made to enter a user
code, the keypad is locked for 30 minutes. If this
message appears, it is still possible to arm/disarm the
system using a keyfob. Arming is possible using a keypad
if one key arming is enabled.
SYSTEM TROUBLE A trouble condition has been detected, press for
further details.
3.7. Arming Tones
Arming tones are the chimes that the system
sounds during the entry/exit delay and when
the system arms or disarms. Various options
are available that determine the pattern of
thesetones.
Armingtonesmaybesoundedbyeithertheexternalwirelesssirenorthecontrolpanel’s
built‐insiren.
3.8. Remote Arming/Disarming
Remote Arming/Disarming via SMS
You can arm and disarm the system remotely by sending the SMS commands from a
cellularphonetothecellularcommunicationsmodule.
EachSMScommandcontainsthefollowingelements:
SMSCommandDescriptor(upto43charactersoffreetext)
#(separatesthedescriptorfromtheactualcommand)
UserCode
Command(120=Disarm,121=FullArm,122=PartArm/Partition1Arm,
123=PerimeterArm/Partition2Arm,124=Full+PerimeterArm,125=Part
FULL ARMING
7 TO EXIT
To Next Page
Loading...
