Appendix C: Glossary
iConnect User Manual
51
S
Scheduling A Home Automation feature that switches HA units on and off
automatically according to pre-set times.
Sensors The devices installed around the home that alert the panel in the
event of an alarm.
Service Call A feature that enables the user to contact the monitoring service
and talk to an operator via the Control System.
SMS Command An SMS message sent to the Control System that causes the
system to perform a specific function.
Smartkey An RF ID device used to arm and disarm the system by placing it
against the Wireless Terminal.
SMS
Confirmation
An SMS message sent to the user confirming that the SMS
command has been performed.
System Status
LEDs
Luminous indicators on the front panel that provide information
on the arm and power status of the system.
T
Telecontrol A feature that provides remote access via the telephone
including remote arming/disarming, siren cancel and Two-
Way audio.
Tones Chimes sounded by the Control System’s internal or external siren.
Trouble Tones Tones sounded by the system to indicate a trouble condition.
TWA Two-Way Audio (abbr.)
TX Transmitter (abbr.)
TX List A service feature that lists all the system’s registered
transmitters, their last recorded status and signal strength.
TX Test A service feature that displays the source of the last received
transmission.
U
Unbypass The restore of original state to a bypassed zone.
User Code A four-digit code that grants access to certain system functions
such as arming and disarming the system.
W
Walk Test A mode that enables sensors to be tested without generating
an alarm.
WUAPP Web User Application Interface (abbr.) Web Application allowing
full interface to the system's user functions.
WAP A protocol used to enable access to the mobile Web via mobile
phone or PDA.
Web Remote
Programmer
Software that enable installers or service providers to operate
and program the system from a PC either on-site or from a
remote location.
Wireless
Terminal
Intelligent two-way wireless keypad with large LCD display that
serves as an additional user interface of the Control System.
Z
Zone A protected area within the security system.
Zone Bypassing See Bypassed Zone
To Next Page
Loading...
