26
COFFEE DISPENSING (2 2GO)
The machine is fitted with dispensing groups that can be turned on and used individually.
The groups are characterised by low thermal inertia, are self-heating, with highly accurate
dynamic infusion water temperature control.
Each group is also fitted with an infusion water pre-heater in order to minimise the thermal
gradient necessary to maintain the desired temperature and also to minimise reaction
times to any temperature adjustment.
This mode allows to settle the infusion water temperature in real-time during the coffee
extraction, in a range of values between 70°C to 95°C.
It is in fact possible to set the operating temperature of each group head independently,
according to 2 different modes: Production or Competition.
2.1 Production operating mode
This mode, by means of the presetting of the extraction temperature and the coffee volu-
me, allows a fully automatic and repetitive production, characterized by execution speed
and consistency of the beverage.
2.2 Competition operating mode
This mode allows the realization in real time, ie during the same delivery, of a curve of the
extraction temperature as a function of the elapsed time or the quantity dispensed, leaving
room for creativity and experience of the Barista to obtain the best possible result with his
coffee.
DISPENSING STEAM (3 2GO)
The machine is equipped with one or two steam dispensers with semi-automatic control
and graduated flow regulator.
The steam is produced by a dedicated boiler, of a capacity of 12 L for 2 group models and
16 L for 3 group models.The steam flow can be adjusted in real time during delivery, with
pressure values between 0.8 and 1.8 bar. Maximum production of milk heated between
5°C and 65°C: 30 Lts/hour per steam wand.
Dispensers are fitted with equipped with swivel wands which allows the use of large milk
or water containers thus guaranteeing good general ergonomics. (
The steam wands are thermally insulated in such a way that they can be operated easily
without causing burns. C4)
DISPENSING OF HOT WATER C4)
The machine is fitted with an automatic hot water dispenser, which can be controlled
according to predetermined configurable values.
Values: from 300cc to 1500cc.
Water temperature: 70/80°C.
The dispenser is fitted with a heat exchanger that heats the water taking it directly from
the water supply.
CONTROL OF WATER LEVEL IN THE BOILER (C10)
This is done by means of a level probe and electrovalves that load the water into the boiler,
topping it up automatically when required.
3
2
4
5
To Next Page
Loading...
