9
This appliance is only electrically safe when it has been
connected to an efficient grounding system in compliance
with current safety regulations .
Make sure that this fundamental safety requirement has
been observed and if in doubt request a thorough check of
the system by a qualified electrician.
The manufacturer cannot be held liable for any damage that
may be caused by failure to ground the appliance.
If the appliance does not have power cable with plug,
at installation the appliance should be connected to the
electricity supply through a multipolar linked switch having a
contact separation of at least 3 mm in all poles, in compliance
with current safety regulations.
Check that the current carrying capacity of the system is
adequate for the maximum rated output of the appliance
(as indicated on the rating plate and, in particular, that the
section of the cables is adequate for the power absorbed by
the appliance.
Unwind the whole power supply cable to prevent dangerous
overheating.
It is forbidden the use of adapters, multiple current taps or
extension cables.
This appliance should not be installed in kitchens.
For the operations of connection to the water supply network,
comply with the provisions in this manual.
This appliance should only be used for the purpose for
which it was designed. Any other use is to be considered as
unsuitable and therefore dangerous.
The manufacturer cannot be held liable for any damage or
injury caused by improper, wrong or unreasonable use.
4
5
To Next Page
Loading...
