Elektron Digitone - Rng; Len; Arp Length; Offset

9. PATTERNS AND SOUNDS
26
9.5.3 RNG
Range sets the octave range of the arpeggiator. After each completed arpeggiator cycle, the arpeggiat-
ed notes are transposed one octave up. When the notes have reached the octave oset specified by the
RNG setting the notes are reset to their initial values. From there the octave transpose is started all over
again.
9.5.4 LEN
Length controls the length of the arpeggiated notes.
9.7.5 ARP LENGTH
Turn DATA ENTRY knob F to elect the length of the arpeggio. The max length is 16 sequencer steps.
9.7.6 OFFSET
Oset selects the oset (note) value of the chosen arpeggiator step in semi-tones. The oset is from the
original note trig. The TRK KEY SCALE and TRK KEY NOTE settings found in the NOTES SETUP menu
aects the note values of the arpeggiated notes.
1. Press [LEFT] or [RIGHT] to select which arpeggiator step to oset.
2. Use DATA ENTRY knob E to set the oset.
3. Press [DOWN] to deacivate an arpeggiator step. Press [UP] to activate an arpeggiator step that
has been deactivated.